Dynasty Spas 2007 Operator's Manual page 24

TROUBLE SHOOTING GUIDE (CONT.)
Spa is leaking
Probable Cause #1 ...................Loose connection.
Action .........................................Hand tighten all disconnects and fittings. Check joints
Motor does not run
Probable Cause #1 ...................No power to motor.
Action .........................................Check power switches and circuit breakers. Check
Probable Cause #2 ...................Pump jammed from foreign matter in impeller.
Action .........................................Call dealer for recommended action.
Probable Cause #3 ...................Motor overheats on hot days while filtering.
Action .........................................Reprogram your controls to cycle during the coolest
Motor runs hot
Probable Cause #1 ...................Pump ran dry.
Action .........................................Call dealer for recommended action.
Probable Cause #2 ...................Restricted suction lines.
Action .........................................Make sure all valves are open/clear suction of debris.
Probable Cause #3 ...................Improper ventilation
Action .........................................Insure that vents on side of spa are free and clear of
Note: These motors will feel hot to the touch. This is normal. The
Overheat Sensor will turn the motor off if there is an overload or high
temperature problem.
Dynasty Spas Operator's Guide • www.dynastyspas.com
24
and unions.
motor plug where plugged into control box.
parts of the day and on shorter cycles. (see
programming instructions).
any debris or landscaping. Spa should also be located
an adequate distance from any walls or fencing for
good ventilation.
WARNING!