Table of Contents
Advertisement
7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-14. To uninstall the light fixture, first disconnect the plug connectors
between the black wire and the red wire.
7-15. Disconnect the plug connectors between the two white
wires.
7-16. Uninstall the connector and washer from the end of the
light fixture inside the lower switch housing.
7-17. Unscrew the threaded rod of the light fixture from the lower
switch housing.
7-18. Remove the light fixture from the lower switch housing
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other plug
connector (female) through the hole.
7-19. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
7-20. Install the switch housing cap and plug button to the lower
switch housing.
7-21. Once you have uninstalled the light fixture, continue
with step 7-6.
Male Dummy
Female Dummy
Terminal
Terminal
14
42507-01 • 09/08/09 • Hunter Fan Company
Threaded Rod
Step 7-18
Cap
Plug Button
Lower Switch
Housing
Step 7-20
Advertisement
Table of Contents
