Wall-Mounting; Wall-Mounting Fixture - Panasonic UB-5310 Installation Manual

Electronic board

Hide thumbs Also See for UB-5310:

Table of Contents

Wall-mounting

The wall-mounting fixture includes the board attachment (upper and lower) supplied with the unit.

Before attempting installation of this wall-mounting fixture, we strongly recommend consulting with the building

manager, engineer, or architect. The installer needs to know the type of construction used for the wall intended for

this installation and the location of wall studs. Selection of hardware is critical for safe wall-mounting, and

depends on the nature of wall construction. Installation should not occur until this consultation takes place.

Caution

• Do not attach the electronic board to mortared walls. Accidental electric leakage from the wall-mounting

fixture bolts to metal laths or wire laths can cause heat, smoke or a fire.

I. Tools required:

A minimum of four (4) pieces of appropriate wall-support hardware (molley, toggle, etc.)

NOTE: THIS HARDWARE MUST BE LOCALLY PROCURED, IT IS NOT INCLUDED IN THE PRODUCT.

Drill (and drill bit of correct size) for hardware installation

Screw driver (Both phillips (+) and slotted (–) will be required.)

Tape measure

Tape or thumb-tacks (2 pcs)

Bubble type level

II. Pre-requisites

1. Before installation, make sure that the wall intended for installation is capable of supporting flush-

mounted.

80 kgf (176 lbs.).

2. The position of the intended installation is of adequate size for the selected Panaboard.

1,440 mm (H) × 1,372 mm (W) [56.7" (H) × 54.0" (W)].

3. An outlet is within 3 m (118.1" ), and not located behind the Panaboard.

Table of Contents