Command Lever; Flash Intensity - Samsung EC-HZ10WBBP User Manual

Command Lever

You can enable the desired features for
the command lever on the back of the
camera.
- [Command Lever] Sub menus:
[EV], [EV(A, S)], [ISO], [WB].
- Move the command lever to the left
or right to select the submenu for each
feature.
Ú For detailed information on using the command lever, refer to Page 30.
z
The [Command Lever] feature is enabled in [Program], [Manual],
[DUAL IS], or [Movie] mode.
z
Selectable sub-menu and default value can vary depending on
recording mode.

Flash Intensity

You can control À ash intensity.
(You can set À ash intensity within the
RECORDING
Command Lever EV range of +/- 1EV in intervals of 0.5EV.)
Flash EVC
ISO
Quality
WB
ACB
OIS
Voice Memo
Back Set
- [Flash EVC] Sub menus:
[+1.0], [+0.5], [0], [-0.5], [-1.0]
z
In [Auto], [DUAL IS], [Beauty Shot], [Nightscene], [Scene], or
[Movie] mode, the [Flash EVC] feature is disabled.
z
If the subject is too close or the sensitivity is too high, changing
the value to a negative value (-) may not have any effect.
z
If the À ash intensity is out of the control range because the
exposure value is too high or low, the camera may not operate
properly.
RECORDING
Command Lever
Flash EVC +1.0
Quality
+0.5
ACB
0
OIS -0.5
Voice Memo
-1.0
Back OK Set
1 1
2008/12/01 PM 01:00 2008/12/01 PM 01:00
051