IBM 9228 - IntelliStation Z - Pro Installation Manual page 47

Table 2. POST error codes (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See the part listing in the Problem Determination and Service Guide to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
00180200 No more I/O space is available for the PCI
adapter.
00180300 There is no memory available above 1MB
for the PCI adapter.
00180400 There is no memory available below 1MB
for the PCI adapter.
00180500 PCI option read-only memory checksum
error.
Action
1. Run the Configuration/Setup Utility program.
2. Reseat each adapter.
Note: If an error LED is lit on an adapter, reseat
that adapter first. If no LEDs are lit, reseat each
adapter one at a time, restarting the computer
each time to isolate the failing adapter.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Failing adapter
b. (Trained service technician only) System board
1. Run the Configuration/Setup Utility program.
2. Reseat each adapter.
Note: If an error LED is lit on an adapter, reseat
that adapter first. If no LEDs are lit, reseat each
adapter one at a time, restarting the computer
each time to isolate the failing adapter.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Failing adapter
b. (Trained service technician only) System board
1. Run the Configuration/Setup Utility program.
2. Reseat each adapter.
Note: If an error LED is lit on an adapter, reseat
that adapter first. If no LEDs are lit, reseat each
adapter one at a time, restarting the computer
each time to isolate the failing adapter.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Failing adapter
b. (Trained service technician only) System board
1. Reseat each adapter.
Note: If an error LED is lit on an adapter, reseat
that adapter first. If no LEDs are lit, reseat each
adapter one at a time, restarting the computer
each time to isolate the failing adapter.
2. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Failing adapter
b. (Trained service technician only) System board
Chapter 5. Solving problems
35