Table of Contents
Advertisement
The following illustration shows how to install the left-side cover on the server.
Complete the following steps to install the server left-side cover:
1. Before installing the cover, check that all cables, adapters, and other
2. Place the bottom lip of the left-side cover over the bottom edge of the server
3. Rotate the left-side cover to a vertical position, inserting the tabs at the top of
4. Slide the left-side cover forward until it locks in place.
5. If you disconnected any cables from the back of the server, reconnect the
48
IBM xSeries 236 Type 8841: Option Installation Guide
Slots
Left-side cover
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
chassis.
the left-side cover into the matching slots in the server chassis.
cables; then, connect the power cords to properly grounded electrical outlets.
Note: If necessary, see Chapter 3, "Input/output connectors," on page 53 for
connector locations.
Advertisement
Table of Contents
