Preparation Before Operation - Hitachi C8FSE - 8-1/2" Sliding Compound Miter Saw Instruction Manual

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Installation
5-13/16"(148mm)
11/32" (9mm)
3 Holes
11-21/32" (296mm)
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1-9/16" (40mm) plus the thickness of the work bench.
For example, use 2-9/16" (65mm) or larger bolts for a 1" (25mm) thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
6mm Bolt
Holder
Adjust the holder
Move
until its bottom
surface contacts the
work bench surface.
Fig. 5
2. Install the side handle (Fig. 6)
Install the side handle that came enclosed with this unit.
Fig. 6
Holder adjustment:
Loosen the 6mm bolt with the supplied 10mm box wrench.
Adjust the holder until its bottom surface contacts the work bench
surface.
After adjustment, firmly tighten the 6mm bolt.
Turntable
Side handle
Tighten
Base 5/16" (8mm) Bolt
Work Bench
Fig. 4
5/16" (8mm) Nut
English
11