Airplay; Network Settings - Panasonic SC-HC57 Owner's Manual

AirPlay

With this feature you can wirelessly stream music
to this unit's speakers.
∫ Compatible devices
AirPlay works with;
≥ iOS 4.2 or later (iPod touch (2nd, 3rd, and 4th
generation), iPhone 4S, iPhone 4, iPhone 3GS,
iPad 2, iPad)
≥ iTunes 10.2 or later (Mac / PC)

Network settings

To use the AirPlay function, this unit must join the
same wireless network as the compatible device.
Preparation
With this unit there are 2 methods to setup the
wireless connection. Determine which type of
wireless network router you are using and follow
the method that matches your device.
≥ Refer to the operating instructions of the wireless
network router for details.
If you do not know which type of wireless network
router you are using, use "Method 2".
≥ Turn the unit on.
≥ When performing the network settings, place this unit close
to the wireless router.
≥ Simultaneous use with other 2.4 GHz devices, such as
microwaves, cordless telephones, etc., may result in
connection interruptions.
≥ Immediately after this unit is turned on, the network setup
may take longer to start.
≥ This unit cannot join a wireless network using WEP security
settings with "Method 1". Use "Method 2" to join the wireless
network.
≥ To cancel this setting in the middle, press [Í] to turn off the
unit.
≥ For up to date compatibility information on your Wireless
router refer to
http://panasonic.jp/support/global/cs/
(This site is in English only.)
(as of December 2011)
Method 1
If your wireless network router supports WPS*
∫ Using the WPS Push Button Configuration
(PBC)
WPS Push Button Configuration
(PBC) compatible wireless router
may have this mark.
1
Press and hold [– WPS] on the unit.
{. "CONNECT" flashes on the display. (Wi-Fi status
indicator blinks blue.)
≥ Complete step 2 within 2 mins.
2
Press the WPS button on the wireless router.
{. When a link is established "LINKING" is indicated on
this unit's display.
{. When the configuration is finished "SUCCESS" is
indicated on this unit's display. (Wi-Fi status indicator
lights blue.)
3
Press [OK] on the remote control to complete
the setting.
≥ This unit can also be set using the WPS PIN code.
Replace step 2 of "Method 1" with the following steps.
(Before starting, refer to the wireless network router's
operating instructions for details on how to enter the PIN
code.)
1 While "CONNECT" is flashing press and hold [– WPS]
again to display the 8 digit PIN code. (Wi-Fi status
indicator blinks purple.)
2 Enter the PIN code into the wireless router.
≥ To edit this system's name it is necessary to use "Method 2".
≥ "FAIL" may be displayed if the connection was not made
within the set time limit. Try the setting again. If "FAIL" is still
displayed, try "Method 2".
Method 2
If your wireless network router does not support
WPS* .
1
With this method, you will access this unit's
wireless network settings from the Internet browser
of your compatible device.
≥ The illustrations and explanations are based on an iPhone.
However, the word "iPhone" can be replaced with your
compatible device.
Preparation
≥ Check your home wireless network name
(Network name (SSID)) and password for this
network. This can often be found on the wireless
router itself.
≥ Turn on your iPhone.
*1: WPS stands for "Wi-Fi Protected Setup
.
1
(Continues to next page)
TM ".
RQT9708
9