Chapter 4 Switch and Jumper Information
REFER TO ADDENDUM
This chapter provides switch and jumper information for the COMPAQ
ProSignia PC Server.
SYSTEM BOARD
Switch locations on the system board are shown in Figure 4-1.
Switch SW2 is a six-position switch bank (S1-S6), which controls the
security features and configuration of the computer.
three position switch bank (S1-S3) that indicates the type and frequency of
the installed microprocessor.
Processor Selection Switch SW4
When upgrading with a new processor, the switch settings for SW4 must be
changed. The settings for supported processors are defined in Table 4-1.
Table 4-1.
Processor Switch Settings
===========================================================================
Processor Installed
---------------------------------------------------------------------------
486/33 or 486DX2/66
Overdrive Processor *
---------------------------------------------------------------------------
*
When available
===========================================================================
System Maintenance Switch SW2
Switch bank SW4 is a
S1
S2
ON
OFF
OFF
ON
S3
ON
ON