Connecting The Cables - Lenovo ThinkServer RD210 Hardware Maintenance Manual

1. If you removed any air baffles, reinstall them now (see "Removing and installing the DIMM air baffle"
on page 77).
2. If you removed the cover, replace it (see "Removing and replacing the cover" on page 72).
3. Install the server in the rack cabinet (see the Rack Installation Instructions that come with the server
for instructions).
4. Reconnect the cables and power cords.
5. Update the server configuration (see "Updating the server configuration" on page 132).
6. Slide the server back into the rack, if necessary.

Connecting the cables

The following illustration shows the locations of the input and output connectors on the front of the server.
1
Hard disk drive activity LED (green)
2
Hard disk drive status LED (amber)
3
Drive bay 0
4
Drive bay 2
5
Drive bay 4
6
Power-control button and LED
7
Operator information panel
8
Operator information panel release latch
9
Video connector
10
USB 1 connector
The following illustration shows the LEDs on the rear of the server.
1
Slot 1, PCI Express
2
Ethernet activity LED
3
Ethernet link LED
4
Video connector
5
Slot 2, PCI Express
11
12
13
14
15
16
17
18
19
11
12
13
14
15
.
Chapter 7 Installing optional devices and replacing customer replaceable units
Rack release latch
USB 2 connector
Optical drive eject button
Optical drive activity LED
Optical drive bay
Drive bay 5
Drive bay 3
Drive bay 1
Rack release latch
USB 3 connector
Serial connector
System-error LED (amber)
System-locator LED (blue)
Power-control button LED (green)
131