Freezer Door - Kenmore 7937 - 22.1 cu. Ft. Top Freezer Refrigerator Use And Care Manual

° Remove the outer lower Decorative Screw from housing at
area between freezer and refrigerator doors.
(You will need this hole for the Middle Hinge Bracket).
30
©
©
° Following illustration, flip the Middle Hinge Bracket (Flange
will now be on top) and position on left side of refrigerator
and re-attach with two bolts and a Phillips screw.
° Place refrigerator door down over pin on bottom hinge.
° Place washer between refrigerator door and middle hinge
and re-attach Hinge Pin to Hinge Bracket with 1/4-in. socket
wrench.
NOTE: Bracket has been flipped, but Hinge Pin stays in the
same orientation with its hexagona! end facing upward.
Middle Hinge
Bracket
° Place Decorative Screw into outer hole on right side of
housing.
° Attach cover on the right side. Cover is force-fitted.
___ .... Screw
REATTACNING FREEZER DOOR
° Put freezer door down over the Hinge Pin on the Middle
Hinge Pin Bracket.
° Place Upper Hinge's Pin in the top of freezer door and line up
the Upper Hinge with holes in top of refrigerator. Use the 3
bolts to replace Hinge.
,f
Fig. 34
• Tighten bolts. Force-fit Top Hinge Cover over Top Hinge.
Fig. 35
° Replace cover from left side of refrigerator top onto the right
of top to cover the holes. Cover is also force-fitted.
Fig. 36
After changing doors, make sure that the corners of the Door
Gaskets are not folded over. To ensure a good seal, apply a
small amount of silicon grease on the corners of gaskets..
Fig. 37
Corners
15