Using The Magnify Feature; Freezing The Screen - Dukane 8055 User Manual

Operating (continued)

Using The Magnify Feature

VIDEO RGB SEARCH
ASPECT AUTO BLANK
MAGNIFY
HOME PAGE UP VOLUME
ON
END PAGE DOWN MUTE
OFF
FREEZE KEYSTONE
POSITION MENU
ENTER
ESC RESET
NOTE
• The projector will automatically exit from MAGNIFY mode if either the
SEARCH, RGB, AUTO, ASPECT or VIDEO feature is used, or, if there is a change in the
input signal's state.
• The correcting keystone condition may vary when the magnify function is active. In
this case, please make the magnify OFF, so the correcting keystone condition will be
restored.

Freezing The Screen

ON
END PAGE DOWN MUTE
OFF
FREEZE KEYSTONE
POSITION MENU
NOTE
• The freezing function will automatically finish if either the STANDBY/ON,
SEARCH, RGB, VIDEO, BLANK, AUTO, VOLUME, MUTE, POSITION or MENU button of
remote control is pressed, or if a button of projector is pressed, or if there is a change
in the input signal's state.
• If the projector continues projecting the same image for a long time (i.e. you forget to
exit FREEZE mode), the image might possibly remain as an afterimage. Do not leave
the projector in FREEZE mode for too long.
20
Press the MAGNIFY (ON) button.
1
The projector enters MAGNIFY mode.
Press the POSITION button, then use the
2
, ,
to zoom. Press the POSITION button again
to finalize the zoom area.
POSITION
3 Use the
level.
Press the MAGNIFY (OFF) button to exit MAGNIFY
mode and restore the screen to normal.(The
projector will also automatically exit MAGNIFY
mode if there is a change in the input signal's
state.)
Press the FREEZE button.
1
The [II] icon appears and the screen will freeze
at the current image. Press the FREEZE button
again and the [
mode.
,
buttons to select the area
,
buttons to adjust the zoom
] appears as the projector exits FREEZE
MAGNIFY MAGNIFY
ON
POSITION
FREEZE