Basic Operations - Toshiba TLP-X150 Owner's Manual

Basic operations

Turn on the power.
1
Turn on the power by following the instructions in "Turning the power on"
2 Select the language and the lamp power during initial
startup.
When the projector is used for the first time after purchase, the start menu for
language selection, lamp power selection and configuration is displayed in English. (If
the screen is out of focus, adjust it according to the step
or
Use the , , button to select the desired language and
1
then press the button.
English
French
German
Italian
Spanish
Portuguese
Russian
Swedish
Turkish
The message for setup confirmation is displayed in the selected language.
Then, the menu for lamp power selection and configuration is displayed. It is
automatically set as Standard. To change the setting, follow the step
Use the or button to select the lamp power and press the

button.
The lamp power, if selected, will be toggled without pressing the
automatically disappears in a few seconds.
Notes
• When the projector is turned on the next time, the start menu will not appear upon
startup. However, if [Reset all] is executed from the Default setting 2 menu
the start menu will be displayed the next time the power is turned on.
• The language can also be set via the Display setting menu
via the Default setting 1 menu
p.40
• This owner's manual assumes that English has been selected.
3 Activate the connected device.
Turn on and start the connected device such as a computer.
4 Press the INPUT button.
An image of the connected equipment is projected.
Each time you press the INPUT button, it switches to the input of the connected
equipment that is outputting video signals.
p.24 .
6
.)
Polish Japanese
Norwegian Chinese (simplified)
Finnish Chinese (traditional)
Czech Korean
Hungarian Indonesian
Greek Thai
Danish Arabic
Dutch
Rumanian
.

button. The display
and Lamp power
p.37
.
6
Notes
• When [Auto input search] is set to [Off] in the Default setting 1 menu
the Input select menu appears if you press the INPUT button. The factory default
setting is [On].
• If no signal is being output from the connected equipment, pressing the INPUT button
does not change the input and "There is no other input signal." message will appear.
5 Adjust projector placement angle
You can adjust the placement angle and the height of the projected image using the
foot adjuster.
Lift up the front of the projector to
1
the desired angle, then press the foot
adjuster release button upward.
The foot adjuster extends. Release the
button to lock the position.
To fine adjust the angle, twist the

foot adjuster.
• To stow the foot adjuster, hold up the
projector while pressing the foot adjuster
release button, then slowly lower the
projector.
Note
• When [Auto keystone] is set to [On] in the Default setting 1 menu, the keystone
distortion will automatically be corrected based on the projector placement angle. If
you do not desire the automatic keystone correction, set [Auto keystone] to [Off].
6 Adjust the screen size and focus
Use the zooming lever to adjust the screen size.
1
,
p.41
Use the focusing lever to adjust the focus.

Adjust the volume with the
7
The speaker volume can be adjusted when an audio signal is being input.
p.40
buttons
Front
7