Advertisement
Available languages
Available languages
=
=
Install Anti-Tip
Bracket
(See instructions
on
page 4.)
Serial Plate Information
The serial plate is located as shown below. See
the serial plate for the following information:
A.Model,
lot and serial number of range.
B.Kilowatt
rating (power requirements).
C.Voltage ratings.
4. Electrical
Connection
Requirements
This appliance
must be properly installed and
grounded by a qualified technician
in accordance
with
the National Electrical Code ANSI/NFPA
No. 70--latest
edition--and
local electrical code requirements.
This appliance
may be connected by means of
permanent
"Hard Wiring" or "Power Supply Cord Kit."
When hard wiring, do not leave excess wire in range
compartment.
Excess wire in the range compartment
may not allow the access cover to be replaced
properly, and could create a potential electrical hazard
if wires become pinched. Connect only as instructed
under "WIRING INSTRUCTIONS"
in sections 6 and 7.
When using flexible conduit or range cable, use flex
connector or range cable strain relief.
NOTE: Only use copper wire in connection
to terminal
block.
4.1 Models
Requiring
Power Supply
Cord
Kit
l
U.S. STYLE
Figure 1 - 3=Wire Cord Kit
Risk of fire or electrical shock may
occur if an incorrect size range cord kit is used, the
installation
instructions
are not followed or strain relief
bracket is discarded.
This appliance
may be connected by means of a
power supply cord. Only a power supply cord kit rated
at 40 or 50 amperes,
125/250 volts, and marked for
use with ranges shall be used. Terminals on end of
wires must be either closed loop or open-end spade
lugs with upturned ends. Cord must have strain relief
clamp.
NOTE: In mobile
home installation
or areas where
local codes do not permit grounding
through
neutral,
a four (4) conductor
power cord must be
used.
A 1-3/8" knock-out hole is provided at the bottom of
the range terminal box for connecting
the power
supply cord kit to the range terminal block (see
Figures 2 and 3).
5. Permanent
Hard Wiring
(3 or 4 Wires)
Insert the residence 3-wire power supply cable
through the 1-1/8" hole at the bottom of the range
terminal box (see Figure 2). For mobile home
application
or where connections
with a 3-wire power
supply cable is not allowed, use a 4-wire power supply
cable (for connections,
see Figure 3). Use a U.L.
approved strain relief clamp to secure the cable to the
terminal box.
6. Wiring
Instructions
= 3-Wire Supply
Cable
ELECTRICAL
GROUND IS REQUIRED
ON THIS APPLIANCE.
Risk of electric shock, frame grounded
to neutral of appliance through a link. Grounding
through the neutral conductor
is prohibited for new
branch-circuit
installations
(1996 NEC); mobile homes;
and recrational vehicles, or in an area where local
codes prohibit grounding through the neutral
conductor. When installed where it is not permitted to
ground through the neutral, the 3-condutor cord or
cable assembly must be replaced by a 4-conductor
cord or cable assembly.
NOTE: If the ground link is removed for any reason, a
separate ground wire must be connected
to the
separate ground screw attached to the range chassis,
and to an adequate ground source.
2
Advertisement
