Switching The Projector On/Off; Power Cord; Power Indicator - Panasonic PTAE2000 Operating Instructions Manual

Switching the projector on/off

Power cord

Connecting
1. Make sure the shape of
the power plug and the
AC IN connector on the
back of the projector
match, then push the plug all the way in.
2. Connect the power cord to a wall outlet.
NOTE:
• Do not use other than the provided power cord.
• Ensure all the input devices are connected and turned off before connecting the power cord.
• Do not force the connector as this may damage the projector and/or the power cord.
• Dirt or dust build-up around plugs may cause fire or electrical hazards.
• Switch off the power to the projector when not in use.

POWER indicator

Indicator status
No illumination or flashing
Red
Flashing
Green
Orange
Flashing
NOTE:
• While the projector is cooling the lamp, do not switch the MAIN POWER button off or unplug the power cord.
• The electric consumption in standby mode is 0.08 W.
POWER indicator
The MAIN POWER button is switched off.
Lit The MAIN POWER button is switched on and the projector is in standby.
The POWER button is switched on and the projector is getting ready to project.
Lit The projector is ready to project.
Lit The POWER button is switched off and the projector is cooling the lamp.
The POWER button is switched on again when cooling the lamp and recovering to
projection mode. Recovery may take a while.
Disconnecting
1. Make sure the MAIN POWER is switched off and
unplug the power cord from the wall outlet.
2. Hold the plug and unplug the power cord from the
AC IN connector on the side of the projector.
Status
E
NGLISH - 19