Monitor Information Window - Panasonic PT-LB1 Operating Instructions Manual

Using WebBrowser

Monitor information window

This page indicates the projector status.
To access this page from other pages, click [Status] in the main menu (at the left of the window).
Projector status
„
On this window, click the [Projector status] tab.
The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View] →
[Refresh].
If [SELF TEST Error (Detail)] appears on the Monitor
information window, click it to view the error details.
If [FAILED] appears
„
Item
MAIN CPU BUS
FAN
INPUT AIR TEMPERATURE
OUTPUT AIR TEMPERATURE
LAMP REMAIN TIME
LAMP STATUS
INPUT AIR TEMP.SENSOR
OUTPUT AIR TEMP.SENSOR
BATTERY
AIR FILTER
(cont.)
There is a problem with a microcontroller circuit. Contact your dealer.
There is a problem with the fan or fan drive circuit. Contact your dealer.
Input air temperature is high. The projector is likely being used in a high temperature
environment such as near heating equipment.
Temperature surrounding the lamp is high. The exhaust vent is likely blocked.
The lamp has been used for longer than its rated useful life, and it is time to replace it.
The lamp could not be lit.
Allow the bulb of the light source to cool, and then turn on the projector.
There is a problem with the air intake temperature sensor. Contact your dealer.
There is a problem with the exhaust temperature sensor. Contact your dealer.
The battery must be replaced. Contact your dealer.
The remaining filter gets low.
For further detail, see the Basic Manual.
Network status
„
On this window, click the [Network status] tab.
Description
11