Table of Contents
Advertisement
Displaying a video image
Remove the lens cap.
Press the Power button on the top of the projector.
The LED flashes green and the fans start to run. When the lamp comes on,
the startup screen is displayed and the LED is steady green. It can take a
minute for the image to achieve full brightness.
? No startup screen? Get help on page 14.
Plug in and turn on the video device.
The video device's image should appear on the projection screen. If it
doesn't, press the Video button on the keypad.
Adjust the height of the projector by pressing the release button to extend
the elevator foot. Rotate the leveling foot, if necessary.
Position the projector the desired distance from the screen at a 90 degree
angle to the screen. See page 39 for a table listing screen sizes and distances
to the screen.
remove lens cap
press Power
turn on video device
adjust height
elevator
foot
adjust distance
12
rotate
leveling
foot
Advertisement
Table of Contents
