Setting The Serial Interface Parameters - Brother HL-730 User Manual

English: HL-YL User's Guide, Chapter 4
USER'S GUIDE

Setting the Serial Interface Parameters

4–2
If necessary, select the interface type as follows:
1. Make sure that the printer is in the off-line state.
2. Select the RS-422A(Apple) or RS-232C(IBM) interface by changing
the serial interface slide switch to the right for IBM(RS-232C) or to
the left side for Apple(RS-422A).
Fig. 4-1 Selecting the RS-422A (Apple)
or RS-232C (IBM) Serial Interface
Note
This section is only for printer models which have had the serial interface
installed.
!
Caution
Be sure to set the parameters to match your computer as follows:
Never change the RS-422A parameters for Apple Macintosh
computers. Because the RS-422A parameters have been correctly set
at the factory for Apple Macintosh computers, you do not need to
change the settings. You may skip this section. If you change
parameters for the RS-232C serial interface and you switch back to
RS-422A for Apple Macintosh computers, be sure to restore the
parameters to the factory settings.
Set the RS-232C parameters to match your computer. You can set
serial settings in several different places, within your DOS application,
within the Windows Printer Icon (for Windows application software
only), or within your AUTOEXEC.BAT file using MODE commands.
For information on serial interface parameters, see the user's guide of
your computer or software.