Step 3: Charge The Battery; Step 4: Turn On Your Hp Ipaq - HP FB040AA Product Manual

2. Place the battery cover down and slide up until it locks into place.

Step 3: Charge the battery

CAUTION:
aligned before connecting.
The battery provides power for your HP iPAQ to operate.
It takes approximately 2–4 hours to fully charge the battery for the first time. Subsequent charges might
take longer.
1. Connect the AC adapter to an electrical outlet and connect the other end of the AC adapter to the
female jack plug of the HP 24-pin connector synchronization cable.
2. Connect the HP 24-pin connector end of the HP 24-pin connector synchronization cable to the
Docking connector on your HP iPAQ. The cable connector fits only one way. If the connector does
not insert easily, turn it over.
NOTE:
at least two seconds. In case the HP iPAQ does not turn on, attach the AC adapter to turn on your
HP iPAQ.

Step 4: Turn on your HP iPAQ

Press the Power key to turn on your HP iPAQ. Next, follow the instructions on the screen to complete
the setup. Use the on-screen keyboard to enter information.
8 Chapter 4 Set up your HP iPAQ
To avoid damaging your HP iPAQ or the AC adapter, make sure all connectors are properly
Whenever a replacement battery is inserted into your HP iPAQ, press the Power key for