Asus F1A55-M LX PLUS R2.0 User Manual page 34

4. Serial ATA 3.0 Gb/s connectors (7-pin SATA3G_1~6)
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can
create a RAID 0, RAID 1, and RAID 10 configuration through the onboard controller.
F1A55-M LX PLUS R2.0
F1A55-M LX PLUS R2.0 SATA 3.0Gb/s connectors
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
• You must install Windows
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
1-24
SATA3G_4
SATA3G_3
SATA3G_2
SATA3G_1
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.5.2 SATA Configuration for details.
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows XP SP3 or later version.
®
[AHCI]. See section 2.5.2 SATA Configuration for details.
SATA3G_6
GND
RSATA_TXP6
RSATA_TXN6
GND
RSATA_RXN6
RSATA_RXP6
GND
SATA3G_5
GND
RSATA_TXP5
RSATA_TXN5
GND
RSATA_RXN5
RSATA_RXP5
GND
XP Service Pack 3 or later version before using Serial
®
Chapter 1: Product introduction