I
NSTALLING SOFTWARES
1
Install the software
Connect yepp´
TM
2
set up the environment
3
Format Flash Memory or the yepp´
Card(Smart media card).
System Requirements
N
Pentium 133MHz or faster
N
Windows 95/98 NT 4.0 or higher
N
CD-ROM drive
N
20MB free hard disk space
N
Available parallel port(ECP or ECP/EPP)
16
ENG
to PC and
TM
S
ETTING UP ENVIRONMENT
N The yepp´
TM
is designed to work in ECP mode. So check whether your computer supports ECP mode
before using your yepp´
TM
. To check the mode, go to My Computer
➔
Device Manger
Port.
N If your computer is not in ECP mode, select ECP mode by entering BIOS mode after rebooting
your computer. Refer to your operations manual provided with your computer or contact the place
where you purchased PC.
If your computer does not support ECP mode, select EPP or Bi-directional mode.
(However, some old model computers will not able to communicate with your yepp´
in EPP or Bi-directional mode.)
➔
➔
➔
Control panels
System
TM
ENG
17