Table of Contents
Advertisement
5.4.4
JMicron
The JMicron
®
Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1.
Two SATA HDDs, preferably with the same model and capacity.
2.
A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a
USB flash disk drive (Windows Vista)
3.
Microsoft
Windows
®
4.
Motherboard support DVD with JMB363 driver
Complete the following steps before you create a RAID set:
1.
Install two external Serial ATA hard disk drives on your system.
Set the Controller Mode item in the BIOS to [RAID]. See section 4.5.5
2.
Onboard Devices Configuration for details.
Onboard Device Configuration
J-Micron eSATA/PATA Controller
Controller Mode
Marvell Gigabit LAN 1
LAN Boot ROM
Marvell Gigabit LAN 2
LAN Boot ROM
VIA Firewire 1394
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
3.
Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4.
Create a JMB363 RAID driver disk for Windows
5.5 Creating a RAID driver disk for details.
5.
Install the JMB363 driver after the Windows
Always install the JMB363 driver before creating RAID sets.
ASUS Blitz Extreme
RAID Configuration
®
OS installation disk (Windows XP)
®
BIOS SETUP UTILITY
Advanced
[Enabled]
[IDE]
[Enabled]
[Disabled]
[Enabled]
[Disabled]
[Enabled]
Options
Enabled
Disabled
Select Screen
Select Item
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
®
OS installation. See section
®
OS had been installed.
5-39
Advertisement
Table of Contents
