Using The Dispenser Drawer - Whirlpool WFW94HEAW Use And Care Manual

Cycle Status Lights
Model WFW94HE shown
Delay Wash
If a Delay Wash is set, the Delay Wash indicator will light and
the delay time will count down in the display.
Door Locked
Door Locked will light to indicate that the door is locked and
cannot be opened without first pausing or canceling the cycle.
Sensing
When START is touched, the washer will first perform a
self-test on the door lock mechanism and the sensing light
will come on. You will hear a click, the drum will make a partial
turn, and the door will unlock briefly before locking again.
Once the door has locked the second time, the washer will
begin tumbling and adding water. This sensing process will
continue throughout the cycle. You may also hear water
flowing through the dispenser, adding detergent to the load.
After the load size is sensed, the estimated time based on
load size will be displayed. The actual cycle time may be
lengthened; however, the display will continue to show the
estimated time.
The sensing light will blink once a second at various times
during the cycle, such as when the washer is reducing extra
suds.
Add Garment
When "Add Garment" is lit, you may pause the washer, open
the door, and add items.
Steaming
This will light to show that the cycle is using a steam boost for
added cleaning power.
Done
Once the cycle is complete, this light will come on. Remove
the load promptly for best results. The Done indicator is also
lit during Fan Dry or TumbleFresh
Fan Dry/TumbleFresh
™
The Fan Dry/TumbleFresh
Dry/TumbleFresh option is active. During this time, the
™
washer will occasionally tumble the load. During Fan Dry only,
a fan also circulates fresh air through the washer.
Eco Monitor
The Eco Monitor allows you to see how the settings you select
affect your energy savings. To use the Eco Monitor, choose
the best cycle, temperature, spin speed, soil level, and options
for the fabrics being washed. The Eco Monitor will rate the
water and energy use of those selections, from Good to Best.
You can then adjust the settings and options to decrease the
amount of energy used within that cycle.
6
.
™
indicator will light when the Fan
™

USING THE DISPENSER DRAWER

1. Open the dispenser drawer.
2. Add laundry products as described in steps 4–6 in the "Using
Your Washer" section.
3. Slowly close the dispenser drawer. Make sure it is
completely closed.
NOTE: A small amount of water may remain in the dispensers
from the previous wash cycle. This is normal.
Adding HE detergent to dispenser
Selector
Pour a measured amount of HE
detergent into detergent compartment.
For powdered detergent, lift the selector
to the high position. For liquid detergent,
push down the selector to the low
position.
Do not overfill; adding too much
detergent may cause detergent to be
dispensed into the washer too early.
Selector
in high
position
Powdered detergent:
Lift the selector to the high
position.
IMPORTANT:
Do not add single-dose laundry packet to dispenser
n
drawer.
Use powdered detergent when using the Delay Wash
n
option. Liquid detergent may seep out before the wash
begins.
HE detergent
compartment
Use only High Efficiency
(HE) detergent.
Selector
in low
position
Liquid detergent:
Push down the selector to
the low position.