Washer Maintenance - Maytag MHW9000YG Use And Care Manual

13.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has
completed to avoid odor and rusting of
metal objects on garments. When unloading
garments, pull back the door seal and check
for small items between the tub and the basket.
If you will be unable to remove the
load promptly, use the Fresh Hold
If the Fresh Hold option is selected, the
™
washer will automatically activate the fan
and tumble the load periodically for up
to 16 hours.
NOTE:
After any wash cycle is completed,
n
the door must be opened and then
closed before a new cycle can begin.
A small amount of water may remain in the dispensers after
n
the wash cycle is complete. This is normal.
This washer has a tight seal to avoid water leaks. To avoid
n
odors, leave the door open to allow the washer to dry
between uses.
14
option.
™

WASHER MAINTENANCE

CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this recommended
cleaning procedure at least once a month:
1. Make sure laundry drum is empty.
2. Using recommended affresh
tablet to washer basket
OR
If using liquid chlorine bleach, add 1 cup (240 mL) to
liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN WASHER
cycle. Do not use more than recommended amount of
bleach to avoid damaging product over time.
3. Close washer door.
4. Press POWER/CANCEL.
5. Select CLEAN WASHER with affresh
6. Press and hold START/PAUSE.
NOTE: The door will lock and the cycle will start. The
washer will add some water, and the basket will rotate
while the washer runs a short sensing cycle. This will take
approximately 3 minutes.
7. The cycle will determine whether clothing or other items
are in the washer. If no items are detected in the washer,
it will proceed to Step 8.
If any items are detected in the washer, a reminder will
be displayed on the screen and the door will unlock.
Open and remove any garments in the wash drum.
Press POWER/CANCEL to cancel the error message.
Then repeat steps 3–6 to start the cycle again.
8. Once the cycle has started, allow it to finish. If you must
cancel the cycle before it has finished, press POWER/
CANCEL. A confirmation message will appear in the
display. It may take up to 20 minutes for the door to
unlock.
9. After the cycle has ended, leave the door open slightly,
to allow for better ventilation and drying of the washer
interior.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use mild soap and water if needed.
IMPORTANT: To avoid damaging washer finish, do not use
abrasive products.
washer cleaner, add one
®
cycle.
™