Samsung WA476DSHASU/A1 User Manual page 16

installing your washer
STEP 2
Connecting the water and the drain
Connecting the water supply hose
To avoid leaks, make sure that your water supply hoses
have rubber seals at both ends. Please make sure to use
CAUTION
new water supply hoses to connect to the water faucets.
Do not reuse old hoses. Only use new hoses when you
install the washing machine. Old hoses could leak or burst
causing fl ooding and property damage.
When you initially install the washer, be sure to use a new
hose. Failing to do so may result in a water leakage or
CAUTION
overfl ow and may damage your property.
Do not connect multiple water supply hoses. This may
result in a water leakage and electric shock due to the
CAUTION
water leakage. If the hose is too short, replace the hose
with a longer, high pressure hose.
1. Connect the ends of the water supply hoses to the HOT and COLD faucets.
2. Tighten the fi tting by hand until it is snug, then make two-thirds of a turn
with a wrench.
CAUTION
3. Prepare a bucket for the water that will be emitted when you open
the faucets connected to the two water supply hoses to remove any
foreign substances from them.
4. Connect the ends of the water supply hoses to the water supply
intake connections at the back of the washer.
CAUTION
16_ installing your washer
WA484DSHA-03050D_EN.indd Sec3:16 WA484DSHA-03050D_EN.indd Sec3:16
When you fasten the fi tting, do not fasten it excessively or apply tape
or sealant to the faucet or water supply intake. This may damage the
fi tting.
After you have connected the water supply hose to the faucet,
ensure that it is connected correctly by pulling the water supply hose
downwards.
The water supply hose connected to the HOT faucet must be
connected to the hot water supply intake and the water hose
connected to the COLD faucet must be connected to the COLD
water supply intake.
Hose-Connector
Rubber Seals
Cold Hot
2012-07-02 2012-07-02 3:39:20 3:39:20