Wire Connection - GE WSM2700WWW - 27" Unitized Spacemaker Washer Installation Instructions Manual

CONNECTING APPLIANCE USING

3-WIRE CONNECTION

1
Remove the terminal block cover located at the
rear of the dryer.
2
Install a UL-recognized strain relief in the one-inch
hole on the dryer back below the terminal block
opening.
3
Install a UL-listed 30A, 3-conductor NEMA 10–30R-
type SRDT cord with 3 open-end spade lug
connectors with upturned ends or closed loop
connectors.
4
Connect the center wire of the power cord to
the silver-colored center terminal screw on
the terminal block. Tighten the screw securely.
5
Connect the two other wires of the power cord to
the outer brass-colored terminals on the terminal
block. Tighten the screws securely.
6
Tighten the screws securing the power cord to
the strain relief.
7
Reinstall the terminal block cover.
CAUTION:
Be sure electricity is OFF at power
source (circuit breaker/fuse box).
8
Plug power cord into electrical outlet.
9
Return to Step 15 on page 3.
NOTE: THIS APPLIANCE IS NOT APPROVED FOR 120-VOLT
OPERATION.
Installation Instructions
Center
silver-colored
screw
3-WIRE CONNECTION (UNGROUNDED
NEUTRAL)
This appliance is manufactured with the neutral
connected to the frame. If local codes do not permit
neutral grounding, proceed as follows:
10
Remove the terminal block access cover.
10A
Disconnect the green ground wire from the green
ground screw.
10B
Connect green ground wire to center (silver-
colored) terminal of terminal block.
10C
Connect a separate grounding wire (No. 12
or heavier—not supplied) between the green
ground screw and a grounded metal cold water
pipe or other established ground.
Ground wire
#12 minimum
(not supplied)
Green
ground wire
10D
Reinstall the terminal block access cover.
CAUTION:
source (circuit breaker/fuse box).
10E
Plug power cord into electrical outlet.
10F
Return to Step 15 on page 3.
NOTE: THIS APPLIANCE IS NOT APPROVED FOR 120-VOLT
OPERATION.
5
Ground clamp
attach to metal
cold water pipe
Green
ground screw
Center
silver-colored
screw
Be sure electricity is OFF at power