Rear Panel Connections - BBE Sonic Maximizer 262 User Manual

REAR PANEL CONNECTIONS

6. A.C.INLET: This jack is for connecting the 12 VAC power source.
7. POWER SWITCH: This push button switch applies AC power to the BBE 262 Sonic Maximizer and is used for turning the unit
on and off.
8. FOOTSWITCH INPUT: This mono jack is for connecting any mono shorting footswitch. Using the remote switching jack
defeats the front panel function switch and allows the selection of process on/off via footswitch.
9/11. UNBALANCED OUTPUTS: Each channel is equipped with a 1/4" phone jack. Each output sends a low impedance line
level signal. The recommended single load impedance is at least 10k Ohms. (The 'load' is determined by the input impedance of the
next subsequent component in the signal chain). The maximum output is rated at +17dBu. The output impedance of the BBE 262 is
1k ohm. NOTE: Actual output level will vary due to the selected position of the BBE Process, and the actual input signal level.
10/12. UNBALANCED INPUTS: Each channel is equipped with a 1/4" phone jack. Input range can be any level from -45dBu to
+6dBu. The input impedance of the BBE 262 is 50k ohms.
4 - BBE 262 INSTALLATION INSTRUCTIONS