Front Panel Controls - BBE Sonic Maximizer 262 User Manual

FRONT PANEL CONTROLS

1 2 3 4 5
1. CHANNEL A: LO CONTOUR CONTROL: Each channel is equipped with a LO CONTOUR control. This control is a low
frequency adjustment for the BBE 262. It provides a boost of 10dBu when turned to its maximum position (clockwise) at 50Hz.
When turned to its minimum position, (counter-clockwise), the low frequency is flat.
2. CHANNEL A: PROCESS CONTROL: Each channel is equipped with a BBE PROCESS control. The BBE Process gives the
user a more detailed perception of tonality, added 'bite' and an increase in clarity. The low frequency range of the program material
will be tightened while the high end will be crystal clear without adding or creating any additional noise or harmonic distortion.
When the knob is in its minimum position, completely counter-clockwise, no process is taking effect. Turning the knob clockwise,
will introduce the BBE Process. Adjust the knob to mix the desired amount of BBE Process to suit your taste. The BBE Process
also has its own in/out switch for comparison of the processed to unprocessed signal located on the front panel. Experiment with the
process. Use the BBE Process as an extension of the tone controls. The BBE Process is not an effect, but a sonic improvement. To
start, set the BBE PROCESS knob to its 12 o'clock position, then adjust accordingly.
3. CHANNEL B: LO CONTOUR CONTROL: Same as Channel A Lo Contour Control.
4. CHANNEL B: PROCESS CONTROL: Same as Channel A Process Control.
5. BBE FUNCTION: This switch engages the BBE Process. When depressed, the 'IN' position, the indicator LED will illuminate
Green indicating that the BBE Process has been engaged. When in the 'OUT' position, the indicator LED will illuminate RED,
indicating that the BBE Process has been disengaged.
BBE 262 INSTALLATION INSTRUCTIONS - 3