Chapter 7 Service Support Software; Control Panel; Test Print Mode - Brother HL 5030 - B/W Laser Printer Service Manual

CHAPTER 7
1.

CONTROL PANEL

1.1

Test Print Mode

The printer incorporates various test print modes.
Select the test mode you want to use following the steps below;
(1) Turn off the power switch of the printer and check that the front cover is closed.
(2) Turn on the power switch while holding down the Go button. Press the Go button until the
Toner LED comes on.
The Toner LED illuminates to indicate that the printer enters into the test print mode.
(3) If you want to execute the test print, release and then press the Go button again when the
Toner LED comes on.
If you want to execute another option, hold down the Go button to select it as shown in the
table below. Release and then press the Go button to execute the selected option.
LED
Toner
Drum
Paper
Status
(yellow)
Status
(green)
SERVICE SUPPORT SOFTWARE
Type of mode
Test Sample Page
Print Fonts
(HL-5040/5050/5070N only)
Factory Reset
Network factory reset
(APIPA: ON)
Network factory reset
(APIPA: OFF)
HL-5030/5040/5050/5070N SERVICE MANUAL
The printer prints a test sample page. The
printer returns to the ready status after printing.
*As for U.S. model, it will correspond from
October, 2003 production.
The printer prints a list of the internal fonts.
The printer returns to the ready status after
printing.
The printer is restored to the factory setting
and permanent fonts and macros are cleared.
The printer returns to the ready status after
printing.
The network setting is reset to its factory
setting. (APIPA is ON)
Refer to Section 6.2 of Chapter 2.
The network setting is reset to its factory
setting. (APIPA is OFF)
Refer to Section 6.2 of Chapter 2.
7-1
Function