MINOURA VFSG-9 Instruction Manual page 7

Put the left end of the quick release
3
skewer (lever side), or axle nut, into
the left side coupling.
Now, adjust the coupling angle so that
the large cutout clamps and lever are
adjusted for easier fitting.
Turn the Hub Handle in a counter-
clockwise direction to close the
coupling.
After engaging the right end of the
quick release skewer (nut side), turn
the Hub Handle until it's locked.
Turning 1 or 2 rotations is crucial for a
secure installation (Fig. I).
Ease the rear wheel down to the drive
4
roller (see Fig. J).
Now the installation is completed and
you are ready to ride.
5 Now make sure that the Mount
Base is not touching the tire (see
Fig. K).
Lift up the bike again, straighten
the Sub Frame and the Mount
Base then ease the wheel down
again.
If the tire is touching the Sub
Frame, the resistance unit position
is wrong.
Go back to the Step-4 on the
page-5 to adjust to the correct
position.
- 7 -
<Fig. I>
<Fig. J>
<Fig. K>