Table of Contents
Advertisement
ASSEMBLE YOUR VFS-G TRAINER
Assemble the Sub Frame onto the Main Frame:
1
The metal Sub Frame Back Plate must be
placed on the bottom of the Sub Frame as
shown in Fig. A.
Insert the M8 Nylon Nut into the hole on the
backside of the Sub Frame. The nylon side
must face inward.
Tighten the M8x20 Bolt and M8 Washer firmly
from both sides.
Install the Unit Base bracket to the
2
resistance unit:
Make sure the bracket direction is correct
as shown in Fig. B. Wrong direction will not
make the next step successful.
Install the assembled resistance unit
3
onto the Mount Base:
Slide the Unit Base bracket into the
Mount Base.
Choose the best position by referring
Step-5, then fix it by tightening M8x15
Bolt and M8 Washer firmly from both
sides.
M8x20 Bolt
M8 Washer
M8x15 Bolt
M8 Washer
- 4 -
M8 Nylon Nut
<Fig. A>
Unit Base
M6x14 Bolt
<Fig. B>
Mount Base
<Fig. C>
Advertisement
Table of Contents
