How To Setup - MINOURA M70-R Instruction Manual

How To Setup Your M70-R/M80-R Trainer
Replace your rear wheel quick release skewer to the supplied one.
1.
Minoura guarantees the stability only when using the supplied skewer due to the coupling inner shape.
!
If your bike is not equipped with quick release skewer and it's a hub nut type,
replace the left side coupling (UF-8) to the optional "Left Side Coupling for Hub
Nut Axle".
Minoura doesn't guarantee the stability if you don't replace the left side coupling.
You don't need the supplied quick release skewer if your wheel is a hub nut type.
!
It's not possible to convert your wheel from the hub nut type to the quick release
skewer type unless replacing the hub.
Install the Mag unit and the Roller Pressure Adjust
2.
Knob set (MF-3) to the frame. (see Fig. A)
Remove the pre-installed bolt from Base Plate
(LM-10).
Attach Mag unit to the bracket on frame, align the
holes, and put through the bolt.
Tighten the bolt with 10mm spanner and M4 hex
wrench.
Do not overtighten the bolt,
!
otherwise the Mag unit will
not move smoothly even if
you rotate the knob.
If properly installed,` the
Mag unit will come down
slowly with its own weight
when you release it.
Install the knob set to the welded nut on the bracket.
Make sure the acorn shaped spring
!
direction is as shown in Fig. A.
Failure will cause difficulty on rotating.
Fully open both legs and place M70-R/M80-R
3.
on a flat and level floor. (see Fig. B)
At this moment, make sure all 4 foot are
contacting the floor at once to sit on the floor
stable.
Required Tools:
- Page 4 -
1 x 10mm Spanner
1 x M4 Hex Wrench
(Fig. A)
(Fig. B)