Advertisement
How To Setup Your M20-D Trainer
Replace your rear wheel quick release skewer to the supplied one.
1.
Minoura guarantees the stability only when using the supplied skewer due to the coupling inner shape.
!
If your bike is not equipped with quick release skewer and it's a hub nut type,
replace the left side coupling (UF-8) to the optional "Left Side Coupling for Hub
Nut Axle".
Minoura doesn't guarantee the stability if you don't replace the left side coupling.
You don't need the supplied quick release skewer if your wheel is a hub nut type.
!
It's not possible to convert your wheel from the hub nut type to the quick release
skewer type unless replacing the hub.
Install the Roller Pressure Adjust Knob set (MF-3)
2.
to M20-D frame . (see Fig. A)
Insert the flat washer and acorn spring into the
knob bolt first, then screw the knob set to the
welded nut on the bracket.
Make sure the acorn shaped
!
spring direction is as shown in
Fig. A.
Failure will cause difficulty on
rotating.
If you feel some difficulty
!
of the vertical action of the
Mag resistance unit, slightly
loosen the pivot bolt which
connects the Mag unit to the
frame.
Do not over-loosen the pivot
bolt. It may cause injury to
your finger when you lift up
the trainer.
Fully open both legs and place M20-D on
3.
a flat and level floor. (see Fig. B)
At this moment, make sure all 4 foot are
contacting the floor at once to sit on the
floor stable.
Required Tools:
- Page 4 -
1 x 10mm Spanner
1 x M4 Hex Wrench
(Fig. A)
(Fig. B)
Advertisement
