Advertisement
INSTRUCTIONS FOR ADJUSTING HEIGHT OR REVOLVING FORM
Should the revolving form "drag" on the Form Finisher base rather than turn freely, the form
must be raised.
Conversely, if the revolving form rides too high above the Form Finisher base, permitting steam
to escape from the space between the form and base, the form must be lowered.
WHEN AN ADJUSTMENT MUST BE MADE, REMOVE REVOLVING FORM BY SIMPLY
LIFTING IT SRAIGHT UP OFF THE FORM FINISHER BASE
PROBLEM: Revolving Form "drags" on base of Form Finisher
TO CORRECT: Loosen F-286 Bearing Lock Nut. Turn F-287 Bearing Adjustment Screw
COUNTER-CLOCKWISE.
CHECK ADJUSTMENT:
perfectly adjusted, form will rotate freely and snugly on felt seal around top of base. If form is
still too low...or too high...repeat adjustment until it is correct.
PROBLEM: Revolving Form rides too high above Form Finisher base.
TO CORRECT: Loosen F-286 Bearing Lock Nut. Turn F-287 Bearing Adjustment Screw
CLOCKWISE.
CHECK ADJUSTMENT:
perfectly adjusted, form will rotate freely and snugly on felt seal around top of base. If form is
still too high...or too low...repeat adjustment until it is correct.
CISSELL FORM FINISHER
CISSELL FORM FINISHER
CISSELL FORM FINISHER
CISSELL FORM FINISHER
CISSELL FORM FINISHER
Replace revolving form on Form Finisher base. Rotate form. If
Replace revolving form on Form Finisher base. Rotate form. If
Page 10
Page 10
Page 10
Page 10
Page 10
Advertisement
