Table of Contents
Advertisement
NAVIGATION
9 Route Plan
Once you have entered your
destination and confirmed it is correct,
you will be taken to the Route Plan
screen; from here you can begin
navigating, carry out a simulation of the
route or add additional waypoints to the
journey.
Tap
to return to the Free
Navigation Menu screen.
Select a destination so that it is highlighted orange and tap
to view the location on
the map.
9.1 Navigating
To begin navigating to you entered destination tap
. The unit will begin to calculate
a route from your current location to your destination. Once calculated the screen will
change to the route navigation screen and you are ready to drive.
While you are navigating it is still possible to browse the map (see page 19). Note that the
unit will continue to navigate if you are moving, but your position on the map will not be
updated and no voice prompts will be given. Tap
to return or wait for 10 seconds after
which the unit will automatically resume normal navigation.
While the unit is calculating the route you can tap
at any time to cancel the route
and return back to the Route Plan screen.
9.2 Waypoints
You can add up to two additional
destinations before you begin navigating,
these additional destinations are know as
waypoints. When the unit calculates the
route it will navigate you to each waypoint
first before continuing on to your final
destination. This is handy if you are
planning a trip were you would like to stop
off on the way to take in sights or simply
just for a break/fuel.
To add waypoints tap
, you will be taken to the Search Menu screen. You can
then enter your waypoint in the same way that you did for your destination (see page 19).
To remove a waypoint/destination, select the desired location so that it is highlighted
orange and then tap
. The waypoint/destination will be removed from the list.
Navigating using waypoints
35
Advertisement
Table of Contents
