Advertisement
To switch the JVC HD camcorder to MPEG-2 mode:
1. Turn on your camcorder and flip open the camcorder's LCD
monitor to reveal the camera panel. In the camera panel,
switch i.LINK OUT to DV and switch off your camcorder.
2. Connect your JVC HD camcorder to your computer's IEEE-
1394 port using the IEEE-1394 cable.
3. Turn on your camcorder and switch it to Play mode. Check
the Device Manager to see if your camcorder is detected.
4. Switch off your camcorder and unplug the camcorder from
the computer.
5. Turn on your camcorder. Flip open the camcorder's LCD
monitor to reveal the camera panel. In the camera panel,
switch i.LINK OUT to MPEG2 and switch off your
camcorder.
6. Connect your JVC HD camcorder again to your computer's
IEEE-1394 port using the IEEE-1394 cable.
7. Turn on your camcorder and switch it to VTR mode.
8. The Found New Hardware Wizard will open. Select
Install from a list or specific location (Advanced) and
click Next.
Note: If the wizard does not automatically open, go to
Start: Control Panel - Add Hardware.
9. Select Don't search. I will choose the driver to install
and click Next.
10. Select Sound, video and game controllers and click
Next.
11. Select JVC in the Manufacturer list and JVC Tape
Device in the Model list. Click Next.
12. A message will prompt you to continue installing the driver
or not. Click Yes.
5
Advertisement
