GMC SIERRA DENALI 2002 Manual page 132

3. Return to HomeLink in your vehicle and firmly
press and release the programmed HomeLink button
three times.
-
The rolling code garage door opener should now
recognize HomeLink. You may either use HomeLink or
-
the hand held transmitter to open the garage door.
If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
the internet at www.homelink.com.
Canadian Programming
Canadian Owners: During programming, the hand
transmitter may automatically stop transmitting after
two seconds. In this case, you should press and hold
the HomeLink button (see Steps 2 and 3 under
"Programming the HomeLink Transmitter") while you
-
press and re press (cycle) your hand
every two seconds until HomeLink is trained.
- - -
800 355 3515, or on
-
held
-
held transmitter
Operating the HomeLink Transmitter
Press and hold the appropriate button on HomeLink
for at least half of a second. The indicator light will
come on while the signal is being transmitted.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Release both buttons.
Resetting Defaults
To reset HomeLink to default settings, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Continue to hold both
buttons until the HomeLink indicator light turns off and
then release both buttons.
Accessories
Accessories for the HomeLink Transmitter are available
from the manufacturer of the unit. If you would like
additional information, please contact the manufacturer
- -
of HomeLink at 1 800 355
www.homelink.com.
-
3515, or on the internet at
2-59