Removing And Installing Memory Modules - Sony PCG-FRV28 User Manual

Removing and Installing Memory Modules

Make sure you read the safety information in
When installing a memory module, do not open the module package until you are ready to install it. The package protects
the module from Electrostatic discharge (ESD).
For memory upgrades and information about which memory modules to use, refer to your VAIO
available on the Welcome
To remove a memory module
1. Turn off the computer and all attached devices.
2. Disconnect the power cord, all cables, and remove the battery if it is installed. See
3. Wait for the computer to cool down.
The interior of the computer becomes extremely hot during operation. Wait at least one hour for the computer to
cool down before you remove the screws.
4. Turn the computer over and use an appropriate screwdriver to loosen and remove the screw(s) on the memory
bay.
To avoid damaging the computer, do not remove or loosen any other screws.
Rem ov ing the Bottom Screw(s)
5.
Remove the cover.
6.
Touch a metal object (such as the connector panel on the back of your computer) to discharge static electricity.
Avoid touching any part of the motherboard or other components inside the computer.
7.
Remove the memory module by pulling out the tabs (see arrow No. 1), and pulling out the module in the direction
of arrow No. 2. See
Rem ov ing a Mem ory Module
To install a memory module
1. Remove the new memory module from its packaging, and install the memory module by sliding it into the open
Precautions and Procedures
page.
To install a memory module
before you remove or install a memory module.
for more information.
Computer Specifications
®
To remove a battery.
Page 123