Honeywell 6271C - Ademco TouchCenter Color Keypad User Manual page 32

Fire Alarm System Operation (cont'd)
c. Press the CLEAR button and then enter your code. This will
clear the Fire Alarm from the system.
2. If the keypad does not indicate a READY condition after the
second sequence, press the DISPLAY FAULTS key on the Arming
screen to display the zone(s) that are faulted. Be sure to check
that smoke detectors are not responding to smoke or heat
producing objects in their vicinity. In this case, eliminate the
source of heat or smoke.
3. If this does not remedy the problem, there may still be smoke in
the detector. Clear it by fanning the detector for about 30 seconds.
4. When the problem has been corrected, clear the display by
entering the DISPLAY FAULTS button on the Arming screen,
selecting the fire zone, pressing the CLEAR button and then
entering you user code.
Note: Contact your Security Company for servicing if you have
further problems with your fire system.
32