Download Print this page
Corsair Hydro H70 Installation Manual

Corsair Hydro H70 Installation Manual

Hydro series high-performance hydro cpu cooler

Advertisement

Quick Links

A
B
INTEL 115x/1366
AMD AM2/AM3
LGA2011
G
H
x4
x4
High-Performance Hydro CPU Cooler
C
D
AMD AM2/AM3
INTEL 115x/1366
I
J
x2
x4
NOTE: In most cases it is necessary to remove
the motherboard from the case before installing
a new CPU cooler.
REMARQUE : Dans la plupart des cas, il est
E
nécessaire de retirer la carte mère du boîtier
x4 • INTEL LGA 2011
avant d'installer un refroidisseur d'unité centrale.
HINWEIS: In den meisten Fällen muss das
Motherboard aus dem Gehäuse genommen
werden, bevor ein neuer CPU-Lüfter installiert
werden kann.
F
NOTA: nella maggior parte dei casi è necessario
rimuovere la scheda madre dalla struttura
x4 • INTEL 1155/1156
esterna prima di installare un nuovo dissipatore
& AMD AM2/AM3
per la CPU.
NOTA: en la mayoría de los casos es necesario
extraer la placa madre de la carcasa antes de
instalar un nuevo ventilador de la CPU.
:
K
x4
.

Advertisement

loading

Summary of Contents for Corsair Hydro H70

  • Page 1 High-Performance Hydro CPU Cooler NOTE: In most cases it is necessary to remove the motherboard from the case before installing a new CPU cooler. REMARQUE : Dans la plupart des cas, il est nécessaire de retirer la carte mère du boîtier x4 •...
  • Page 2 Übersetzungen der Garantie in andere these terms with respect to which losses or damages are claimed. Sprachen finden Sie unter: In no event will Corsair Memory be liable for any loss of use, loss of time, inconvenience, commercial loss, lost profits or savings www.corsair.com/cooling...
  • Page 3 Install the backplate Install the retention ring Install the cold plate/pump unit Installez la plaque arrière Installez l'anneau de retenue Installez la plaque froide et la pompe Rückwand installieren Halterungsring installieren Kühlfläche/-pumpe installieren Installare la piastra posteriore Installare l'anello di sicurezza Installare la piastra di ra reddamento/unità...
  • Page 4 Tighten screws on retention ring Install the radiator Connect power to fan and pump Installez le radiateur Serrez les vis sur l'anneau de retenue Reliez les ventilateurs et la pompe à l'alimentation Kühler installieren Schrauben am Halterungsring festziehen Lüfter und Pumpe anschließen Installare il radiatore Avvitare le viti dell'anello di sicurezza Collegare ventole e pompa all'alimentazione...
  • Page 5 46221 Landing Parkway • Fremont • California • 94538 • USA © 2010-2011 Corsair Memory, Inc. All rights reserved. Corsair and the sails logo are registered trademarks, and Hydro Series is a trademark in the United States and/or other countries.

This manual is also suitable for:

Hydro h70coreHydro series