Installing The Monitor Driver In Windows Xp - Lenovo 4422HB6 User Manual

Installing the monitor driver in Windows XP

To use the Plug and Play feature in Windows XP, files should be loaded from the
Reference and Driver CD.
Note: This section must be completed before continuing with the Windows XP
automatic image setup.
1. Turn off the computer and all attached devices
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot into
Windows XP.
4. Open the Display Properties window by clicking Start
Panel, and then double-clicking the Display icon.
5. Click the Setting tab.
6. Click the Advanced button.
7. Clink the Monitor tab.
8. Clink the Properties button.
9. Clink the Drivers tab.
10. Open the Hardware Update Wizard window by clicking on Update Driver,
and then click Next.
11. Select Install from a list or Specific location (Advanced), and then click Next.
12. Insert the Setup CD into the CD driver, then click the Have Disk button.
13. Click on the Browse button and navigate to the following directory:
X:\Monitor Drivers\Windows XP
(where X is the drive letter designator for the CD-ROM drive).
14. Select the "L2240pwD.inf" file and click the Open button. Click the OK button.
15. Choose L2240pwD and click OK. The files will be copied
from the CD to your hard disk drive.
16. Close all open windows and remove the CD.
17. Restart the system. The system will automatically select the maximum refresh
rate and corresponding Color Matching Profiles.
Note: On LCD monitors, unlike CRTs, a faster refresh rate does not improve
display quality. Lenovo recommends using either 1680x 1050 at a refresh rate of 60
Hz, or 640x480 at a refresh rate of 60Hz.
Settings Control
Chapter 3. Reference information
3-5