Erasing Homelink Buttons; Reprogramming A Single Homelink Button; Security - Dodge 2007 Dakota Owner's Manual

etc.). For convenience, the hand-held transmitter of the
device may also be used at any time. In the event that
there are still programming difficulties or questions,
contact HomeLink at: www.homelink.com or 1-800-355-
3515.

Erasing HomeLink Buttons

To erase programming from the three buttons (individual
buttons cannot be erased but can be reprogrammed -
note below), follow the step noted:
• Press and hold the two outer HomeLink buttons until
the indicator light begins to flash-after 20 seconds.
Release both buttons. Do not hold for longer that 30
seconds. HomeLink is now in the train (or learning)
mode and can be programmed at any time beginning
with Programming - step 2.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 115

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. Do
NOT release the button.
2. The indicator light will begin to flash after 20 seconds.
Without releasing the HomeLink button, proceed with
Programming step 2
For questions or comments, contact HomeLink at:
www.homelink.com or 1-800-355-3515.

Security

Garage Door Opener Operation with Security
Alarm (if equipped)
If your vehicle is equipped with the Security Alarm
feature, the operation of the HomeLink feature will be
purposely inhibited if the Security Alarm is Armed .
This prevents HomeLink operation due to un-authorized
3