Understanding Auto Eq Error Messages; Indicator List - Pioneer MVH-P7300 Operation Manual

Appendix
Additional information
iTunes tagging
Message Cause
iPod full. Tags
Memory used for
not trans- tag information
ferred. on the iPod is
full.
Memory full. This unit's flash
Tags not memory used as
stored.
the temporary
storage area is
full.
Tag transfer
This unit's tag in-
failed. Recon- formation cannot
nect your transfer to the
iPod. iPod.
Tag store Tag information
failed. cannot be stored
in this unit.
SD source can- Tag information
not be se-
is being trans-
lected during
ferred to the
tag transfer. iPod.
Bluetooth Telephone
Message Cause
Error-10 The power failed
for the Bluetooth
module of this
unit.
Understanding auto EQ
error messages
When correct measurement of the car's inter-
ior acoustic characteristics is not possible
using auto EQ, an error message may appear
on the display. In such cases, refer to the table
below to see what the problem is and how it
may be corrected. After checking, try again.
50
En
Action
Sync the iPod with
iTunes and clean
up the tagged play-
list.
Connect the iPod
to this unit and
transfer this unit's
tag information to
the iPod.
Check the iPod
and try again.
Try again.
Wait until tag
transfer is com-
plete.
Action
Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized Pioneer
Service Station.
Message Cause
Error. Please The microphone
check MIC. is not connected.
Error. Please
The microphone
check xxxx
cannot pick up
speaker. the measuring
tone of a speaker.
Error. Please
The surrounding
check noise. noise level is too
high.
Error. Please
Power is not
check battery. being supplied
from the battery
to this unit.

Indicator list

Common
(MVH-P8300BT only)
Indicates that a Bluetooth tele-
phone is connected.
(MVH-P8300BT only)
Indicates the signal strength of the
cellular phone.
Shows when tag information is
stored in this unit.
Flashes when the tag is being
transferred to an iPod.
Action
Plug the optional
microphone se-
curely into the
jack.
! Confirm that the
speakers are con-
nected correctly.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Set the micro-
phone correctly.
! Stop your car in
a place that is
quiet, and switch
off the engine, air
conditioner and
heater.
! Set the micro-
phone correctly.
! Stop your car in
a place that is
quiet, and switch
off the engine, air
conditioner and
heater.
! Connect the bat-
tery correctly.