Chapter 2 Supervisor Engines - Cisco WS-C6503 Manual

Chapter 2 Supervisor Engines
Table 2-2 Supervisor Engine 2 Features (continued)
Feature
Memory
SP DRAM
SP NVRAM
SP onboard flash
Front panel features
Status LEDs
RESET switch
CONSOLE port
PCMCIA slot options
Uplink ports
Uplink port queue structure
OL-7397-03
Description
WS-X6K-S2-PFC2 and WS-X6K-S2-MSFC2—128 MB (default);
•
upgradeable to 512 MB.
WS-X6K-S2U-MSFC2—256 MB (default); upgradeable to 512 MB.
•
512 KB
32 MB
See Table 2-4 for a list of the status LEDs and their descriptions.
The RESET switch allows you to reset and restart the switch.
Use a ballpoint pen tip or other small, pointed object to access the
Note
RESET button.
One 10/100/1000 port that uses an RJ-45 connector. The CONSOLE port
allows you to access the switch either locally (with a console terminal) or
remotely (with a modem). The CONSOLE port is an EIA/TIA-232
asynchronous, serial connection with hardware flow control.
The CONSOLE port has an LED associated with it.
One PCMCIA slot is available. The Flash PC card (PCMCIA) slot holds a
Flash PC card for additional flash memory. You can use this flash memory
to store and run software images or to serve as an I/O device. Supports a
64 MB (p/n MEM-C6K-ATA-1-64M=) ATA Flash PC card. An eject button
is located on the right side, next to the slot. Pushing in on the button ejects
the Flash PC card from the slot.
The PCMCIA slot has an LED associated with it.
Supervisor Engine 2 has two 1000BASE-X uplink ports. The two
1000BASE-X uplink ports require GBIC transceivers.
The uplink ports have LEDs associated with them.
Note In chassis configurations where there are redundant supervisor
engines installed, the uplink ports on the supervisor engine that is in
standby mode are fully functional.
Tx—1p2q2t
Rx—1p1q4t
Catalyst 6500 Series Supervisor Engine Guide
Supervisor Engine 2
2-3