Connecting To The Stackwise Ports (Catalyst 3750-X Switches) - Cisco WS-C3560X-48PF-L Hardware Installation Manual

Connecting to the StackWise Ports (Catalyst 3750-X Switches)

Connecting to the StackWise Ports (Catalyst 3750-X Switches)
Before connecting the StackWise cables, review the
Switches)" section on page
Remove the dust covers from the StackWise cables and StackWise ports, and store them for future use.
Step 1
Use the window in the StackWise cable to align the connector correctly. Connect it to the StackWise port
Step 2
on the switch rear panel
to 5 lbf-in. (80 ozf-in.).
Connect the other end of the cable to the connector on the other switch, and tighten the retainer screws
Step 3
to 5 lbf-in. (80 ozf-in.). Avoid overtightening the screws.
Figure 2-19
Caution
When you need to remove the StackWise cable from the connector, make sure to fully unscrew the
correct screws. When the connectors are not being used, replace the dust covers.
Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
2-20
2-4. Always use a Cisco-approved StackWise cable to connect the switches.
(Figure 2-19). Using a ratcheting torque screwdriver, tighten the retainer screws
Connecting the StackWise Cable in a StackWise Port
Removing and installing the StackWise cable can shorten its useful life. Do not remove and
insert the cable more often than is absolutely necessary.
"Planning a Switch Data Stack (Catalyst 3750-X
C O N S O
L E
A U X
S T A C K R E S E T
1
S T A C K
2
Chapter 2 Switch Installation
OL-19593-02