Table of Contents
Advertisement
Set the time to an FM station's Radio
Data System (RDS) setting
(if equipped)
• Press and hold both HR and MN for
two seconds until UPDATED and the
clock symbol appear on the display.
• Press and hold both HR and MN for
another two seconds to accept and
set the time.
• If the time is not available from the
station, NO UPDAT appears in the
display.
Program radio station presets
• Turn the radio on.
• Press AM-FM to select the band
(AM, FM1/FM2/XM1/XM2).
• Use the seek or tune knob to tune in
the desired station.
• Press AUTO TONE to select the
equalization that best suits the type
of station selected.
• Press and hold one of the six num-
bered buttons until a beep sounds;
release the button.
• Repeat these steps for each station
preset, using a different numbered
button for each station.
Activate the Radio Data System
(RDS) traffic announcement feature
(if equipped)
• Press TRAF. <TRAF> will appear on
the display if the tuned station broad-
casts traffic announcements.
• If the tuned station does not broad-
cast traffic announcements, the radio
will seek a station that does.
• If no station is found, NO TRAF
appears on the display.
Display a station's INFO message
when INFO appears on the display
• Press INFO to see the message.
Once the complete message has
been displayed, INFO disappears
from the display.
Tune to an RDS broadcast of a
selected program type
• Turn the P-TYPE knob to select the
Program Type you want to listen to.
• Press the SEEK or SEEK TYPE
button (as applies to your radio).
Access one of the two available XM
Satellite Radio bands (if equipped)
• Press the BAND button until XM1 or
XM2 appears on the display.
Load one CD into the Six-Disc CD
player (if equipped)
• With the ignition on, press and
release the LOAD side of the LOAD
CD button.
• Wait for the green indicator light at
the right side of the slot to turn green.
• Insert the disc partway into the slot,
label side up; the player will pull the
disc in.
11
Advertisement
Table of Contents
