Features; Using The Air Conditioner - Kenmore 75251 - 24,500 BTU Room Air Conditioner Owner's Manual

1 15 6 5 4 316 2714
_ILT#
tltl
11 i2 10 13 i7
FIG. 22
1. Cabinet
2. Vertical Air
Direction Louvers
3. Horizontal Air
Direction Louvers
4. In_et Grille
5. Air Filter
6. Front Grille
7. Control Board
8. Power Cord
9. Evaporator Coil
10. Condenser
11, Compressor
12. Base pan
t 3.8race
14. Upper Guide
15, Curtain
16. Vent Control Lever
17. Remote Control
USING THE AIR CONDITIONER
To reduce the risk of fire, electric
shock, or injury to persons, re_ the important
SAFETY instructions section before operating this
appliance
To begin operating the air conditioner after
installation, follow these steps:
1. Plug in the air conditioner. (To prevent electrical
hazards, do not use an extension cord or an
adapter plug.)
2. Set the exhaust vent to the CLOSE position,
3. Set the TEMP Control to the coolest setting.
4. Set the MODE control at the highest COOL level
5, A_ust the louvers for comfortable air flow.
6, Once the room has cooled, adjust the TEMP end
Mode Contro_ to the setting you find most
comfortable.
NOTE : if the air conditioner is turned off, wait 3
minutes before restarting. This allows pressure
inside the compres_r to equalize. Failure to wait 3
minutes before restarting may cause inefficient
operation,
if you move the TEMP Contro_ to a warmer, then
immediately back to a cooler setting, the unit will
shut off. Wait 3 minutes before restarting.
VENT CONTROL
The Vent Control allows the air conditioner to
either recirculate inside air (CLOSE) or exhaust
air to the outside (OPEN). (FIG. 23)
• The CLOSE position is used when maximum
cooling is desired It may also be used for air
recirculation without cooling when the air
conditioner is set in the FAN position.
• The OPEN position removes stale air from the
room and exhausts it to the outside. Fresh air is
drawn into the room through your home's
normal air passages
• The OPEN or CLOSE _sition can be used with
any fan selection.
PULL OPEN ! PUSH CLOSE
FiG. 23
-10-