Symantec PCANYWHERE - PACKAGER IMPLEMENTATION GUIDE V1.3 Implementation Manual page 56

56 Configuring custom commands
Configuring custom commands
To specify operating system support
1 In the Symantec Packager window, on the Configure Products tab, do one of
the following:
Create a new custom command.
■
Double-click an existing command to edit it.
■
2 In the Command Editor dialog box, on the Operating Systems tab, select the
operating systems on which the custom command can run.
The default selection is Any operating system. You can limit the installation
by category, (for example, all Windows NT platforms), by specific operating
system (for example, Windows 2000 and Windows XP), or by any
combination (for example, all Windows NT platforms plus Windows 98 and
Windows 98 SE).
3 Do one of the following:
Click OK to save your changes and close the Command Editor dialog
■
box.
Click Apply to save your changes and continue configuring the
■
command.
4 If prompted, type a file name, and then click Save.