Table of Contents
Advertisement
of the access point with which it associates.
Wireless Mode when Starting an Ad Hoc Network: Specifies 2.4 GHz 300/54/11 Mbps
to start an Ad Hoc network if no matching network name is found after scanning all
available modes. This mode also allows the selection of the channel that the Wireless
Adapter uses. The channels available depend on the regulatory domain. If the adapter
finds no other ad hoc adapters, the channel that the adapter starts the ad hoc network with
will be selected automatically. The Adapter must match the wireless mode and channel of
the clients it associates.
802.11 Authentication Mode: Select which mode the Adapter uses to authenticate to an
access point:
•
Auto causes the adapter to attempt authentication using shared, but switches it to
open authentication if shared fails.
•
Open enables an adapter to attempt authentication regardless of its WEP settings. It
will only associate with the access point if the WEP keys on both the adapter and the
access point match.
•
Shared only allows the adapter to associate with access points that have the same
WEP key.
For infrastructure (access point) networks, click Preferred APs... to specify four access points
at most to the client adapter that attempts to be associated to the access points. The four
access points have different priorities; the frontal has the higher priority.
3.1.2.2. Remove a profile
1.
Go to the Profile Management tab (shown in Figure 3-2).
2.
Select the profile name in the Profiles List.
Click Remove.
3.
Note:
The profile being used can't be removed.
TL-WN851N
300Mbps Wireless N PCI Adapter
Figure 3-7
24
Advertisement
Table of Contents
