Connecting The Network (Distribution System) - Cisco AIR-WLC4402-50-K9 Installation And Configuration Manual

Installation and Configuration

Connecting the Network (Distribution System)

See the following figure for connections from the network (Distribution System) to the controller.
•
•
Depending on the Distribution System physical port to be assigned in Configuring Cisco Wireless LAN
Controller Interfaces in the Product Guide, use ethernet CAT-5, CAT-5e, CAT-6, or CAT-7 cables or
SX/LX/LH compatible fiber optic cables to connect the network equipment to the Controller.
Figure 5
78-17157-01
For the 4402 controller, up to two of the following connections are supported in any combination:
1000BASE-T (GigE, front panel, RJ-45 physical port, UTP cable).
–
– 1000BASE-SX (GigE, front panel, LC physical port, multi-mode 850nM (SX) fiber-optic links
using LC physical connectors).
– 1000BASE-LX (GigE, front panel, LC physical port, multi-mode 1300nM (LX/LH) fiber-optic
links using LC physical connectors).
For the 4404 controller, up to four of the following connections are supported in any combination:
– 1000BASE-T (GigE, front panel, RJ-45 physical port, UTP cable).
1000BASE-SX (GigE, front panel, LC physical port, multi-mode 850nM (SX) fiber-optic links
–
using LC physical connectors).
– 1000BASE-LX (GigE, front panel, LX physical port, multi-mode 1300nM (LX/LH) fiber-optic
links using LC physical connectors).
Physical Network Connections to 4402 and 4404 Controllers
Model 4402
Two 1000BASE-SX,
-LX, or -T
Network
Cisco 4400 Series Wireless LAN Controllers - Installation and Configuration Guide
Connecting the Network (Distribution System)
Model 4404
Four 1000BASE-SX,
-LX, or -T
21